.png?ts=1778831753)
SMS COM SPC 8 and 16 A
€175.00
Product information "SMS COM SPC 8 and 16 A"
Description
SMS COM SPC 8 and 16 amp climate controller
After unpacking, check the SPC for transport damage, voltage and frequency. Never install the SPC near water pipes, rain, drains, etc., and make sure the power is switched off. Keep the work area clean and dry! Installation of the SPC and the correction of defects must be carried out by a qualified electrician in accordance with the applicable standards.
Start-up
Switch in position "AUTO": the SPC works fully automatically. The fans are controlled according to the settings. After switching on the SPC, the connected fans always start at full voltage for a few seconds.
Switch in position "0": in this position the SPC is switched off.
Switch in position "100%": if the automatic control no longer works in the event of a fault,
the connected fans must be switched to this position.
They then run at full mains voltage.
Instructions for use:
* Set the minimum ventilation level (e.g. 20%).
* Set the maximum ventilation level (e.g. 80%).
* Set the ventilation bandwidth. The control range between minimum and maximum ventilation remains at least 10% regardless of the settings (e.g. 2 °C).
* Set the desired temperature. If the indoor temperature rises above the set
target temperature, the SPC selects the appropriate ventilation level according to the set bandwidth.
Features
* Precise climate control!
* Can be connected and operated by anyone!
* Minimum and maximum speed adjustable
* Plug & play: ready to use straight away!
* Including 5-metre temperature sensor
Caution!
The SMSCOM SPCs are matched to the most common fans. However, it is possible to reset the minimum speed using the "cal. Min" potentiometer (to the left of the fuse holder). Left is minus and right is plus. Set it so that the extraction always keeps running at the minimum extraction setting. A LOWER SETTING INCREASES THE RISK OF HUMMING. If the SPC is switched off (0 position) and then on again, first set the switch to 100% and only then to the auto position. This is recommended to protect connected extractors.
Login